Click the switch, Switch0, and click FastEthernet0/2 to connect to PC-B.This indicates the correct cable type has been used. After about one minute two green dots should appear on both sides of the Copper Straight-Throughcable. Click the switch, Switch0, and select a connection port, FastEthernet0/1, to connect to PC-A.Drag and drop a 2950-24 switch onto the Logical Workspace.Select Switches from the options in the bottom left-hand corner.This will remove the hub and the cables connected to it. Select the hub and click on the red X located on the right side of Packet Tracer.While this network is functional, its performance could be improved by using a switch instead of a hub. In Step 3 you created a network with a hub. Click the hub, Hub0, and click Port 1 to connect to PC-B.Click the second host, PC-B, and assign the cable to the FastEthernet connector.Click the Copper Straight-Through cable type again.Click the hub, Hub0, and click Port 0 to connect to PC-A.Click the red X on the right-hand side of Packet Tracer and delete the Copper Cross-Over cable. The red dots indicate the wrong cable type.Click the hub, Hub0, and select a connection port, Port 0, to connect to PC-A.Click the first host, PC-A, and assign the cable to the FastEthernet connector.Drag and drop a generic hub (Hub-PT) onto the Logical Workspace.Select Hubs from the options in the bottom left-hand corner.Begin this new configuration by using the red X on the right side of Packet Tracer to delete the Copper Cross-Over cable type connecting PC-A to PC-B.Use a hub to connect two or more computers. This type of connection is a simple way to interconnect two computers. In Step 1, two computers were connected using a Copper Cross-Over cable type. The green dots at both ends of the cable indicate the correct cable type. Click the second host, PC1, and assign the cable to the FastEthernet connector.Move the cursor to the cable and click the cable to delete it.This will allow you to delete the Copper Straight-Through cable. Click the red X on the right-hand side of Packet Tracer. The red dots indicate an incorrect cable type.Click the first host, PC0, and assign the cable to the FastEthernet connector.Choose a Copper Straight-Through cable type.Select Connections from the bottom left-hand corner.

Drag and drop two generic PCs (PC-PT) onto the Logical Workspace.

Select End Devices from the options in the bottom left-hand corner.Select the device option that is required. Once the device category is selected, the options within that category appear in the box next to the category listings. To select a device, first select the device category. Move your cursor over the device categories to show the name of the category in the box centered between the rows of devices. The bottom left-hand corner of the Packet Tracer screen displays nine icons that represent device categories or groups, such as Routers, Switches, or End Devices.

Cable to debrick router